Quote:
Originally Posted by bucfan
I got the lamp working and loaded the default program with some mods. I have a few questions about the software.
1. How do I add more set points to the cycle?
2. Preview mode still does not work for me. If i go to preview mode and change light colors nothing happens on lamp.
3. If I change colors on a set point it somehow changes the colors on the next few set points to the same color combo. Quite annoying!
4. I have the 3 LED version. Do I have to change the colors on all 3 LED modules. I noticed that I have to move the set points of all 3 LED modules around to ramp up down at the same time. However not sure about the colors. Does it automatically change for all 3 LED modules or do I have to do each individually?
5. How do figure out firmware version and is it a must to update to the latest?
|
1. There are only a max of 10 set points. I wish there was more. Email ATI and ask them to put in more. If many people ask, they will likely add.
2. When you go into preview mode, there are two previews: one to preview the light cycle in quicktime, and the other is to preview the LED channel settings; if the latter make sure you click on a set point.
3. Not sure with this. Works fine for me.
4. You can create one led module, then use the led spot COPY command to copy the same for the other two.
5. Firmware version is witten on the window frame, just above setting tab. I still have version 1.2.0.2 as it works fine for me.