Waves using Profiles

[Elitemodel24]

Hey Guys,
I have set the below profiles on my Apex Jr. For some reason, my powerheads aren't doing anything. I have two Sicce Voyager HP10s on a 220 gallon tank. It is as if my Outlets aren't recognizing my profiles. Is there somewhere that you have to enable Profiles? I currently have the Apex Jr., EnergyBar8, and PM1. Please help... Anybody

Variable Speed Pump 1 and 2

Stream Rt (This is my Tunze pump on the right side of tank. VS1)

Set Wave1
If Time 10:00 to 10:59 Then duskdawn
If Time 11:00 to 19:00 Then Wave1
If Time 19:01 to 20:00 Then duskdawn
If Outlet Timer = ON Then Flush1
If Time 20:01 to 09:59 Then Night
If FeedA 000 Then OFF

Stream Lt (This is my Tunze pump on the left side of tank. VS2)

Set Wave1
If Time 10:00 to 10:59 Then duskdawn
If Time 11:00 to 19:00 Then Wave1
If Time 19:01 to 20:00 Then duskdawn
If Outlet Timer = ON Then Flush2
If Time 20:01 to 09:59 Then Night
If FeedA 000 Then OFF


Pump Profiles:
Wave 1 (This keeps a constant surge going that makes the corals dance)
Synchronize Enabled
Divide by 10 Enabled
Initial off time (Seconds) 0
On time (Seconds) 7
Off time (Seconds) 4
Minimum intensity 0
Maximum intensity 100


Night (This mode allows for less erratic flow at night)
Synchronize Disabled
Divide by 10 Disabled
Initial off time (Seconds) 0
On time (Seconds) 10
Off time (Seconds) 15
Minimum intensity 30
Maximum intensity 50

Flush 1 (This mixes things up throughout the day)
Synchronize Disabled
Divide by 10 Disabled
Initial off time (Seconds) 0
On time (Seconds) 30
Off time (Seconds) 30
Minimum intensity 0
Maximum intensity 100

Flush2 (This mixes things up throughout the day)
Synchronize Disabled
Divide by 10 Disabled
Initial off time (Seconds) 30
On time (Seconds) 30
Off time (Seconds) 30
Minimum intensity 0
Maximum intensity 100

DuskDawn
Synchronize Enabled
Divide by 10 Enabled
Initial off time (Seconds) 0
On time (Seconds) 7
Off time (Seconds) 4
Minimum intensity 0
Maximum intensity 50


Timer (Used to control the flush cycle)
OSC 060:00/010:00/000:00 Then ON

[kurt_n]

You mention you have Sicce Voyager HPs, but refer to Tunze in your programming. The Sicce Voyagers aren't variable speed pumps, are they? I thought they were just 'plug them in and they run' pumps. You can't use profiles with just on/off pumps.

[aquamanic]

You say they're not doing anything. If you put their outlet to Manual ON do they go on?

Are these pumps variable speed or just on/off?

edit** Kurt beat me to it. I think these are single speed pumps.

[RussM]

You can't be doing variable speed. Apex Jr needs a VDM to have VarSpd ports and therefor use pump profiles. Only Tunze pumps can be used this way.