AM pinpoint ph controller, plz advise

Polyp Envy · 01/27/2014, 04:55 PM

at the moment, i jus wana use this as a ph monitor. i will not be using any setpoints or anything nor do i have any other equipment attached to the controller. i simply wana monitor my in tank ph for now. i will use the controller as it was meant as i aquire the rest of my calrx pieces.

please advise if there is anything i should know, or any helpful advise you can give me. please and thank you.

Polyp Envy · 01/27/2014, 04:58 PM

and yes i am and have been reading through the intructions, but i jus wana have some extra input.

Pallobi · 01/27/2014, 06:22 PM

It's pretty simple, I just did mine last week... just read through calibration part, and make sure you go back and forth between cal fluids until you consistently get the proper reading for each without having to adjust... The unit will need to be set to read first and you wana start with the 7.0... And make sure you rinse in room temp fresh water before and after each dip into each cal fluid... Don't let the probe dry out either... Then once it's stable, just mount the probe somewhere you want in your sump or whatever... And keep it on read... I too haven't made it much further than that... Good luck!

01/27/2014, 04:55 PM	#1
Polyp Envy Registered Member Join Date: Sep 2013 Posts: 118	AM pinpoint ph controller, plz advise at the moment, i jus wana use this as a ph monitor. i will not be using any setpoints or anything nor do i have any other equipment attached to the controller. i simply wana monitor my in tank ph for now. i will use the controller as it was meant as i aquire the rest of my calrx pieces. please advise if there is anything i should know, or any helpful advise you can give me. please and thank you.

01/27/2014, 04:58 PM	#2
Polyp Envy Registered Member Join Date: Sep 2013 Posts: 118	and yes i am and have been reading through the intructions, but i jus wana have some extra input.

01/27/2014, 06:22 PM	#3
Pallobi CTARS, BRS & OSRAS Member Join Date: Apr 2010 Posts: 7,001	It's pretty simple, I just did mine last week... just read through calibration part, and make sure you go back and forth between cal fluids until you consistently get the proper reading for each without having to adjust... The unit will need to be set to read first and you wana start with the 7.0... And make sure you rinse in room temp fresh water before and after each dip into each cal fluid... Don't let the probe dry out either... Then once it's stable, just mount the probe somewhere you want in your sump or whatever... And keep it on read... I too haven't made it much further than that... Good luck!