Mp40 slave pump issues

Joeb1983 · 08/17/2016, 06:29 PM

Posted this in Ecotech as well, but I have 2 mp40's with upgraded Quite Drivers paired running anti-sync.

For some reason my slave pump keeps reverting back to the lowest speed and staying there no matter what mode I place the master in.

The dial remains orange indicating slave relationship and the "W's" are lit on both drivers, but like I said; it stays at the 1st dot speed making one side of my tank dead for flow.

This used to happen once in a while and I would simply cycle power and all was well.

Now its taking a hard reset and re-pairing which will last a week or so.

RF modules are correctly and securely installed as well as all connections.

Drivers are ~ 5.5 ft apart in cabinet.

Any ideas? Did it again today...

08/17/2016, 06:29 PM	#1
Joeb1983 Registered Member Join Date: Feb 2014 Location: Stationed in Oklahoma, but from Florida. Posts: 597	Mp40 slave pump issues Posted this in Ecotech as well, but I have 2 mp40's with upgraded Quite Drivers paired running anti-sync. For some reason my slave pump keeps reverting back to the lowest speed and staying there no matter what mode I place the master in. The dial remains orange indicating slave relationship and the "W's" are lit on both drivers, but like I said; it stays at the 1st dot speed making one side of my tank dead for flow. This used to happen once in a while and I would simply cycle power and all was well. Now its taking a hard reset and re-pairing which will last a week or so. RF modules are correctly and securely installed as well as all connections. Drivers are ~ 5.5 ft apart in cabinet. Any ideas? Did it again today...