|
|
|
01/13/2006, 09:52 PM
|
#1 |
|
Registered Member
Join Date: Jul 2005
Location: apple valley ca
Posts: 27
|
wow got water movement
got my two tunze stream 6080 and my two phosban reactor 150 in my tank last night..
got the tunzes in the front and the two seio m620 in the back.. now i have 23.916666 turn over without my sump return pump i can not belive the water movment i have now.. those tunze put out.. got water movement now now my phosphates were at over 1.0 last night.. 12 hour later ther were .1 then at 24 hour the same.. i am useing two little fishies phosban media.. do you think it is all used up .. as there was no chage in 12 hour or do you think it will take longer.. as i used most of the 200g bucket of phosban to fill both reactor .. iam thinking i was so high that the media is used but i do not have enough media to refill both reactor again.. thanks marlen |
|
|
|
01/13/2006, 11:12 PM
|
#2 |
|
Registered Member
Join Date: Jan 2002
Location: Delray Bch FL
Posts: 1,846
|
If your po4 went from 1.0 ppm to 0.1ppm I would say your media is just about spanked. Leave it in, if you see your po4 rise change it out.
Paul
__________________
" Whats that water on the floor " Current Tank Info: something to look at |
|
|
|
|
01/13/2006, 11:20 PM
|
#3 |
|
Registered Member
Join Date: Mar 2004
Location: Pacifica, California. (15 Miles South of San Francisco)
Posts: 2,013
|
Heh...23 turnover is ok... I have a little over 56.5 turn over in my 29, and I still have dead spots
__________________
-Rich |
|
|
|
 |
|
|
