|
07/17/2014, 10:27 AM | #1 |
Registered Member
Join Date: Jan 2014
Location: Palm Harbor, FL
Posts: 2,997
|
DIY Jebao Battery Backup - Which Way is Best?
As the title says. Which way is best for a Jebao battery backup? Of course, I guess using a relay would limit me to only 24v DC appliances.
|
07/17/2014, 01:12 PM | #2 |
Registered Member
Join Date: Feb 2014
Location: Charlotte Harbor, FL
Posts: 97
|
I'm confused but how are you going to get 24v from a 12v battery?
If you decide to do either do not charge the batteries indoors. I too use multiple batteries to power my tank during an outage but never charge them inside to to the gases that they put off while being charged. I don't have mine on a transfer switch. I just set it up on an as needed basis.
__________________
new 180 waiting on the bacteria to do their thing. |
07/17/2014, 10:40 PM | #3 | |
Registered Member
Join Date: Jan 2014
Location: Palm Harbor, FL
Posts: 2,997
|
Quote:
Yes, absolutely putting the battery outdoors, enclosed in a battery box, wired through the exterior block wall. I guess my question really was what's better, the relay or transfer switch, but after some thought I went the transfer switch route for the added benefit of powering different equipment if necessary. I thought about leaving it not hooked up, but living in Florida with weekly thunderstorms and lots of power outages, I want the power to be there if I'm not. Hell just this week I lost power briefly and a few homes burnt down in the Tampa Bay area from lightning. I have a generator too (hurricane preps), but the thought of leaving for work, a typical thunderstorm knocking out power early and coming home to a graveyard would be devastating. I already had an extra marine battery from being a boat owner, a Wagan 400 watt pure sine wave inverter and Battery Tender Jr. So the only addition I picked up today was a Kisae 15 amp Transfer Switch for $50 (typically used for boats to switch from shore power to battery or generator and back). I wired everything up and it worked like a charm, automatically switching from utility to battery power and back. (Note: My illustration was wrong. The transfer switch plugs into the inverter and the powerhead plugs into the transfer switch.) I can post pictures on request. |
|
Thread Tools | |
|
|