Plumbing thoughts

[crabbydan]

Getting ready to plumb a new tank and new sump. Tank is custom size 5 feet x 2 feet and 22 inches tall. Stand is a powder coated steel stand about 37 inches tall. Yes looking forward to less crawling under a tank soon. So I cut some plain white pvc to mock my plumbing. First 3 pictures are 3 drain lines with 3 45 degree angles. Clean straight forward. 2nd set of photos is 2 45 degree angles but it looks a little wonky not as straight/clean. Also the third line does cross over the fuge in the sump but shouldn’t get in the way of lights or anything else I throw down there.



Sent from my iPhone using Tapatalk

[crabbydan]

Originally Posted by crabbydan

Getting ready to plumb a new tank and new sump. Tank is custom size 5 feet x 2 feet and 22 inches tall. Stand is a powder coated steel stand about 37 inches tall. Yes looking forward to less crawling under a tank soon. So I cut some plain white pvc to mock my plumbing. First 3 pictures are 3 drain lines with 3 45 degree angles. Clean straight forward. 2nd set of photos is 2 45 degree angles but it looks a little wonky not as straight/clean. Also the third line does cross over the fuge in the sump but shouldn’t get in the way of lights or anything else I throw down there.



Sent from my iPhone using Tapatalk

Sorry had trouble uploading multiple pics here is the rest.




The paint stirrer is where this design goes over the sump fuge.



Sent from my iPhone using Tapatalk

[billdogg]

I would try to avoid the 90's if at all possible. IMHO, 45's are a much better choice

[saveafish]

Brace your pips to the back of the stand. Don't let the overflow box or the sump support the weight or vibes.

[mattgumaer]

I would pick the first setup as it keeps more of your sump easily accessible and is less likely to interfere with potential equipment. I don't think I'd worry too much about the 90s on drain lines, although I would try to avoid them on return lines.

Matt

[thegrun]

You are going to want a gate valve on the primary full siphon drain line near the bottom of the drain line just before it goes into the sump.

[crabbydan]

Originally Posted by thegrun

You are going to want a gate valve on the primary full siphon drain line near the bottom of the drain line just before it goes into the sump.

I agree I am just determining direction right now. Straight back angle over to ghost overflow or straight down and cross the sump to the sump intake lines.

In addition to the gate valve I am debating on plumbing a tee and valve on the emergency drain to a temp filter sock ion case I want to run a sock in the future. I am also lining up my return lines and manifold lines to avoid these drain lines.

Good advice thanks!

[Lsufan]

Originally Posted by billdogg

I would try to avoid the 90's if at all possible. IMHO, 45's are a much better choice

I agree, u can plumb those drains without using a single 90. U can do it with only using 3-45’s in each line. It seems u are really trying to keep the pipes out of the way as most as possible, which in that case u would end up having to use 4-45’s on each line. U wouldn’t have any horizontal sections in the pipe. That is still better then using 2-90’s & 1 or 2 45’s & running the pipe horizontaly

[FamilyTank]

I'd go for looks,over functionality in this case if your stand is going to be open. There isn't an appreciable difference.

Watch "BRStv Investigates: Which reduces more flow, 45 or 90 degree elbows?" on YouTube
https://youtu.be/h-PG4a0rU60

[BruceWayne]

Thanks die the video very helpfully