Chiller not holding temperature after power failure

Ludecrasher · 09/15/2013, 07:42 PM

Hello all, I just purchased a JBJ 1/10hp chiller and works great, BUT I just had a power failure and when I woke up my water temp was at 69 degrees!! The settings were set to .5!!!! If I weren't home ALL my fish and corals would've definitely died. What can I do to prevent this from happening again? I'm scared leaving the chiller on now when I go to work.

Pseudo69 · 09/15/2013, 10:43 PM

Use a controller. Apex ,profilux, reef angel or a simple Ranco controller.

09/15/2013, 07:42 PM	#1
Ludecrasher Registered Member Join Date: May 2013 Location: Lomita, CA Posts: 101	Chiller not holding temperature after power failure Hello all, I just purchased a JBJ 1/10hp chiller and works great, BUT I just had a power failure and when I woke up my water temp was at 69 degrees!! The settings were set to .5!!!! If I weren't home ALL my fish and corals would've definitely died. What can I do to prevent this from happening again? I'm scared leaving the chiller on now when I go to work.

09/15/2013, 10:43 PM	#2
Pseudo69 Registered Member Join Date: Mar 2007 Location: New York City Posts: 372	Use a controller. Apex ,profilux, reef angel or a simple Ranco controller.