Programming MP10 with Apex WXM

[burtner]

Hi all. I'm trying to program my feed mode A for my Apex with the WXM module.

During FeedA, I would like my MP10 to go to Reef Crest mode at 20% flow. After the predetermined 5 minute FeedA duration, I want the MP10 to go into Nutrient Transport Mode for an additional 10 minutes.

The problem is that, when I enter FeedA, the MP10 is shutting off completely.

Please help. I'm also going to post on Apex's website, but thought someone here in NY might know.

Here's my code:

If FeedD 000 Then OFF
If FeedA 010 Then Nutrient
If FeedA 000 Then FeedReef20

[cardiffgiant]

You can do this by setting up something on the season table or with a virtual outlet. I set up a virtual outlet called lowPH for my radions. In the programming I did a line that reads somehting like "If ph < 8 then LowPh On"

I'd think that the MP10 programming could be very similar.

[burtner]

Originally Posted by cardiffgiant

You can do this by setting up something on the season table or with a virtual outlet. I set up a virtual outlet called lowPH for my radions. In the programming I did a line that reads somehting like "If ph < 8 then LowPh On"

I'd think that the MP10 programming could be very similar.

Sorry for missing your post. It's hard to switch between this and the facebook group.

I did get it figured out, though. Thanks!

[Schmahlkw]

Trying to setup Feed Mode for my MP10 in the same way. How did you get it to work?

Thanks!!