LED Full Spectrum Controller based on Mega2560 board - Page 9

kapelan · 04/14/2018, 08:47 AM

The system supports 4 temperature sensors.
to find sensor please use button "Find" and then "Save"
pin 46 is used for LED: if any LED ON then fan ON

muelpaul · 06/02/2018, 09:57 PM

Hello Kapelan,
Not sure if you still want to make any changes to these working hex files.

If you would be;
Could the ATO float sensor settings have an option to shut off a power line if switched on?
My number 2 float switch is higher and if switched on would turn off ATO pump controlled from float sensor 1.

Also 12 or 24 hour time and Celsius or Fahrenheit temp.

Did not notice if the timers can do this. I have 2 return pumps each on different power lines and would like to have one on and the other off alternating every 10 seconds.
This could have a minimum of 5 seconds to a max of 5 minutes.

Would you be able to do this?

Thank you,
Paul

04/14/2018, 08:47 AM	#201
kapelan Registered Member Join Date: May 2008 Location: Canada Posts: 159	The system supports 4 temperature sensors. to find sensor please use button "Find" and then "Save" pin 46 is used for LED: if any LED ON then fan ON __________________ my tank online: http://ledacik.com

06/02/2018, 09:57 PM	#202
muelpaul Registered Member Join Date: Aug 2004 Location: New London, WI Posts: 592	Hello Kapelan, Not sure if you still want to make any changes to these working hex files. If you would be; Could the ATO float sensor settings have an option to shut off a power line if switched on? My number 2 float switch is higher and if switched on would turn off ATO pump controlled from float sensor 1. Also 12 or 24 hour time and Celsius or Fahrenheit temp. Did not notice if the timers can do this. I have 2 return pumps each on different power lines and would like to have one on and the other off alternating every 10 seconds. This could have a minimum of 5 seconds to a max of 5 minutes. Would you be able to do this? Thank you, Paul