|
|
|
08/03/2006, 07:47 AM
|
#1 |
|
Registered Member
Join Date: Mar 2003
Location: GA
Posts: 635
|
Sucking Durso
I am setting up my new tank and cant seem to dial in my durso. The pipe's air inlet is controled by a small ball valve which I can adjust. However, I either get the "toilet bowl" effect or it runs up too high and starts flowing down my back-up safety pipe.
Any ideas? Thanks, |
|
|
|
08/03/2006, 07:58 AM
|
#2 |
|
Registered Member
Join Date: Nov 2004
Location: Perry, OK
Posts: 13,946
|
Do you have a picture of this? It doesn't sound like a standard Durso. If it was a standard durso, then just leave the hole for air wide open.
__________________
Travis Stevens Current Tank Info: Restarting 28g Bowfront |
|
|
|
|
08/03/2006, 08:59 AM
|
#3 |
|
Registered Member
Join Date: Mar 2003
Location: GA
Posts: 635
|
It was built by Envision Acrylics along with the tank. I will see if I can post something but those out there that have tanks from James will know what I am talking about.
Thanks for the post |
|
|
|
|
08/03/2006, 09:21 AM
|
#4 |
|
Registered Member
Join Date: Nov 2004
Location: Perry, OK
Posts: 13,946
|
No problem. Sorry that I couldn't help further.
__________________
Travis Stevens Current Tank Info: Restarting 28g Bowfront |
|
|
|
|
08/03/2006, 12:11 PM
|
#5 |
|
Registered Member.
Join Date: Aug 2006
Location: California
Posts: 11
|
try removing the ball valve to see what happens or tape over the hole and make a small hole and then try bigger holes until the noise subsides.
|
|
|
|
 |
|
|
