|
|
|
09/08/2007, 09:01 PM
|
#1 |
|
Registered Member
Join Date: Feb 2005
Location: Cleveland, Ohio
Posts: 2,720
|
couple of questions regarding my new lumenarc mini...
Alright, I have two little eye hole bolts with screw ends, I have found one that screws into the socket so you can hang the extra weight from the mogel.
But where would the second one go? I searched on the entire thing, and didn't see anything. maybe it was just an extra? Also there is two rivet holes that were riveted when this thing was manufactured, what can I plug the holes up with to block the light? then I am going to get a 3 wire quick disconnect. How do I wire this thing up? the 3 wires on the ballast are - 2 red and one greet the 3 wires on the mogel end are - black, white & green. How would I wire these up in a quick disconnect? Just make sure that the greens link up, and the other two it doesn't really matter since there are 2 reds does it?
__________________
Experience the Liquid Realm... |
|
|
|
09/08/2007, 09:06 PM
|
#2 |
|
Registered Member
Join Date: Nov 2002
Location: Orlando, FL
Posts: 427
|
Mine had a hole cut in the top center for the refector. I don't know how you could hang or mount the fixture without at least two holes???
Justin |
|
|
|
|
09/08/2007, 09:18 PM
|
#3 |
|
Registered Member
Join Date: Feb 2005
Location: Cleveland, Ohio
Posts: 2,720
|
yes I'm sorr you are right, there is another hole at the top, but the eye hole screw didnt fit in there. Plus it had no bolt to really lock it on.
so I went to home depot and got a smaller diameter eyehole with a bolt. I guess this one is just extra then?
__________________
Experience the Liquid Realm... |
|
|
|
 |
|
|
