|
|
|
11/23/2012, 08:39 PM
|
#1 |
|
Registered Member
Join Date: Nov 2004
Location: RI
Posts: 104
|
Plumbing help!!!
Below is a picture of my sump plumbing. The left pipe and the third are 1 1/4 PVC that goes into a 1in bulkhead. It comes out as a 1 in. The second from the left is a 3/4 in return. It is teed to feed the third chamber. One ball valve is for the chamber and one is for a 1/2 in nipple to use as a drain for water changes. The last is an open 1 in pipe that will be used as an emergency drain in case anything gets clogged. It will be extended into the third chamber. There is a ehiem 1262 return pump. I have an octopus xs 200. I will have two 4 in filter socks on the two siphon drains. The emergency one will be open. Any questions or suggestions would be appreciated.
|
|
|
|
11/23/2012, 08:41 PM
|
#2 |
|
Registered Member
Join Date: Nov 2004
Location: RI
Posts: 104
|
|
|
|
|
|
11/24/2012, 07:19 AM
|
#3 |
|
Registered Member
Join Date: Nov 2004
Location: RI
Posts: 104
|
The the dt is a 120. And the sump is a 40 breeder.
Sent from my iPad using Tapatalk HD |
|
|
|
|
11/24/2012, 02:02 PM
|
#4 |
|
Registered Member
Join Date: Nov 2004
Location: RI
Posts: 104
|
Anyone?
|
|
|
|
|
11/26/2012, 11:21 AM
|
#5 |
|
Registered Member
Join Date: Nov 2004
Location: RI
Posts: 104
|
I glued the pieces. I have also siliconed in a holder for two 4in filter bags on the two main intake tubes. Any thoughts on these?
|
|
|
|
|
11/26/2012, 11:27 AM
|
#6 |
|
Registered Member
Join Date: Sep 2003
Location: North Carolina
Posts: 20,050
|
Looks good.. keep going.
make sure you support that "return manifold" part so its not just dangling there.
__________________
Who me? |
|
|
|
 |
| Tags |
| plumbing, pvc, sump |
|
|
