Aquavitro Vibrance

Scubajoe1 · 04/06/2015, 07:38 PM

Hey guys,
The instructions on vibrance by sachem states to use 1 ml for each 25 gallons to raise the iodide level by 0.1 mg/mL which is 0.1 ppm. Why do they state the directions in this way. You really want the iodide levels at 0.06 ppm. I am a little confused as to why they state it like this. If I want to raise my iodide levels from 0.04 to 0.06 that means I should add about 1.6 mls to 200 gallons. Also does this raise it all at once or must one add the same amount every day?

Thanks

Scubajoe

bertoni · 04/06/2015, 08:04 PM

If the instructions are correct and the water volume in your system is 200g, then 1.6 ml should raise the iodide level to 0.06 ppm immediately. Each tank is different, so you'll have to test for a while to determine the consumption rate.

Scubajoe1 · 04/06/2015, 08:18 PM

It's a 10,000 ppm solution so the calculation works out. Thanks JB

bertoni · 04/06/2015, 08:58 PM

You're welcome. Good luck!

04/06/2015, 07:38 PM	#1
Scubajoe1 Registered Member Join Date: Jan 2015 Location: Raleigh, NC Posts: 409	Aquavitro Vibrance Hey guys, The instructions on vibrance by sachem states to use 1 ml for each 25 gallons to raise the iodide level by 0.1 mg/mL which is 0.1 ppm. Why do they state the directions in this way. You really want the iodide levels at 0.06 ppm. I am a little confused as to why they state it like this. If I want to raise my iodide levels from 0.04 to 0.06 that means I should add about 1.6 mls to 200 gallons. Also does this raise it all at once or must one add the same amount every day? Thanks Scubajoe

04/06/2015, 08:04 PM	#2
bertoni RC Mod Join Date: Mar 2002 Location: Mountain View, CA, USA Posts: 88,616	If the instructions are correct and the water volume in your system is 200g, then 1.6 ml should raise the iodide level to 0.06 ppm immediately. Each tank is different, so you'll have to test for a while to determine the consumption rate. __________________ Jonathan Bertoni

04/06/2015, 08:58 PM	#4
bertoni RC Mod Join Date: Mar 2002 Location: Mountain View, CA, USA Posts: 88,616	You're welcome. Good luck! __________________ Jonathan Bertoni

04/06/2015, 08:18 PM	#3
Scubajoe1 Registered Member Join Date: Jan 2015 Location: Raleigh, NC Posts: 409	It's a 10,000 ppm solution so the calculation works out. Thanks JB